Features

Troubleshooting


W770

Alarm does not work

No alarm sound is emitted.

Below are possible causes. Try remedies from the top to the bottom.

CauseRemedies
The power reserve is not enough.Charge the watch.
The alarm setting (ALM ON/OFF) is set to "ALM OFF".Change the alarm setting (ALM ON/OFF) to "ALM ON".

Charge the watch.

When the second hand is moving once every two seconds, alarm does not sound. In addition, you cannot check or change the alarm setting (ALM ON/OFF).
Charge the watch.

Change the alarm setting (ALM ON/OFF) to "ALM ON".

When then watch is charged enough, check the alarm setting (ALM ON/OFF) and change it.

  1. Pull the crown out to position 1.
  2. The second hand points to 30 seconds and stops.

  3. Rotate the crown to change the mode to [ALM].
  4. Push the crown in to position 0.
  5. The hour, minute and 24-hour hands indicate the alarm time currently set and the function hand shows the alarm setting (ALM ON/OFF).

  6. Press and release the lower right button A to set the alarm setting (ALM ON/OFF) to "ALM ON".
  7. !

    Each time you press the button, ON/OFF of the alarm setting changes alternately.

  8. Pull the crown out to position 1.
  9. Rotate the crown to change the mode to [TME].
  10. Push the crown in to position 0 to finish the procedure.

!

You can check the alarm setting (ALM ON/OFF) also in the [TME] mode.
When the crown is in position 0, press and release the lower right button A repeatedly to make the function hand indicate the alarm setting (ALM ON/OFF).

Related articles

Indicating alarm setting