Cal. No. H82*
Refine your searchH82*
Receiving the time signal
Receiving the time signal manually (On demand reception)
!
For details of signal reception, see “About signal reception”.
!
It takes up to 15 minutes to finish signal reception.
!
Signals to receive are different depending on the time zone you set for the home time.
For details, see “Table of time zones and representative places”.
- Push the crown in to position 0.
- Press and hold the lower right button A for 2 seconds or more.
- Put the watch in the place with good conditions for time signal reception.
The second hand indicates the result of the last signal reception.
After that, confirmation tone is emitted, the second hand points to “RX” and signal reception starts.
!
Do not move the watch as far as possible while the second hand points “RX”.
After the reception finished, the reception result (OK/ NO) of this time is indicated and the watch returns to normal indication.
To cancel signal reception
Pressing and holding the lower right button A while the second hand points “RX” cancels signal reception and the watch returns to normal indication.