Cal. No. U68*
Refine your searchU68*
Alarm
Changing alarm setting
Check the time zone (area name) setting of the analog and digital indications before pulling out the crown when you want to use alarm based on their times.
- Pull the crown out to position 1.
- Rotate the crown to set the mode hand to [AL-1] or [AL-2].
- Pull the crown out to position 2.
- Press and release the lower right button A.
- Press and release the upper right button B.
- Rotate the crown to change the area name.
- Press and release the upper right button B.
- Rotate the crown to set “Hour” of the alarm time.
- Press and release the upper right button B.
- Rotate the crown to set “Minute” of the alarm time.
- Push the crown in to position 0.
- Pull the crown out to position 1.
- Rotate the crown to set the mode hand to [TME] or [CAL].
- Push the crown in to position 0 to finish the procedure.
An area name and “(M)” appear alternately on the digital indication (L).
!
Turn the crown so that the mode hand will point to the center of the mode name securely.
The current alarm setting of the chosen mode is indicated on the digital indication (R).
The on/off setting of alarm starts blinking.
The on/off setting of alarm changes.
!
Each time you press the lower right button A, the on/off setting of alarm changes alternately.
The area name starts blinking.
!
Set the same name as that of the time zone (area name) setting of the analog or digital indication when you want to use alarm based on their times.
“Hour” of the alarm time starts blinking.
“Minute” of the alarm time starts blinking.
!
Press the upper right button B to return to the on/off setting of alarm.
!
After finishing setting, change the mode of the watch to [TME] or [CAL] following the steps below.
An area name and “(M)” appear alternately on the digital indication (L).
!
Turn the crown so that the mode hand will point to the center of the mode name securely.