Cal. No. E67*
Refine your searchE67*
Receiving the time signal
Receiving the time signal manually (On demand reception)
!
For details of signal reception, see “About signal reception”.
!
It takes up to 15 minutes to finish signal reception.
- Pull the crown out to position 1.
- Rotate the crown to set the mode hand to “TME” or “L-TM”.
- Push the crown in to position 0.
- Press and hold the lower right button A for 2 seconds or more.
- Put the watch in the place with good conditions for time signal reception.
The second hand points to 30 seconds and stops.
!
Turn the crown so that the mode hand will point to the center of the mode name securely.
!
After indication is changed to that of the mode you chose, proceed to the next step.
The second hand indicates the result of the last signal reception.
After that, the second hand points to “RX” and signal reception starts.
!
Do not move the watch as far as possible while the second hand points “RX”.
The second hand returns to normal movement as signal reception finished.
To cancel signal reception
Pressing and holding the lower right button A for 2 seconds or more during signal reception cancels signal reception and the watch returns to normal indication.