Features

Troubleshooting


F158

Problems with satellite signal reception

Reception is unsuccessful.

Below may be possible causes. Try the following remedies in sequence.

CauseRemedies
The second hand moves every two-second. Not one.Charge the watch.
The function hand points "DIVE".Press and release both the lower right button A and the upper right button B at the same time to deactivate the diving mode.
The second hand does not point “RX-TME:” or “RX-GPS”. Press and hold the target button until the second hand points “RX-TME:” or “RX-GPS” (about 2 seconds).
The second hand indicates the current setting just after pressing the button, then points “RX-TME:” or “RX-GPS”.
If not, check and correct the reference position.
The place is not good.Avoiding places where the satellite signal may be obstructed and objects which emit noise, face the dial towards the sky and start reception.
The place is good but the watch is on your wrist.Remove the watch from your wrist and try again.

If the remedies above do not solve the problems, consult an authorized service center.

Related articles

When the watch reaches a low charge state (insufficient charge warning function) Using the diving mode Obtaining location information from satellite signals Time reception For receiving the satellite signal smoothly Checking and correcting the reference position Contact us