Cal. No. U60*
Refine your searchU60*
About signal reception
Changing the automatic reception setting
- Pull the crown out to position 1.
- Rotate the crown to set the mode hand to [RX-S].
- Pull the crown out to position 2.
- Press and release the upper right button B.
- Press and release the lower right button A to change the automatic reception setting.
- After finishing setting, push the crown in to position 0.
- Pull the crown out to position 1.
- Rotate the crown to set the mode hand to [TME] or [CAL].
- Push the crown in to position 0 to finish the procedure.
An area name and “(M)” appear alternately on the digital indication (L).
!
Turn the crown so that the mode hand will point to the center of the mode name securely.
The current setting of the automatic summer time switching function blinks on the digital indication (R).
The current automatic reception setting blinks on the digital indication (R).
!
Each time you press the upper right button B, indication switches between the setting of the automatic summer time switching function and that of automatic reception alternately.
| Indication on the digital indication (R) | Automatic reception |
|---|---|
| AUT (AUTO) | The time of the third automatic reception is kept 4:00 AM. |
| MAN (MANUAL) | The time of the third automatic reception is changed. |
| OFF | Automatic reception is fully deactivated. |
!
Each time you press the lower right button A, the automatic reception setting changes as follows.
MAN -> OFF -> AUT -> (back to the top)
!
“Hour” of the reception time start blinking when you choose “MAN”.
Rotate the crown to choose the time.
You cannot choose 2:00 AM and 3:00 AM.
!
Change the mode of the watch to [TME] or [CAL] following the steps below.
An area name and “(M)” appear alternately on the digital indication (L).
!
Turn the crown so that the mode hand will point to the center of the mode name securely.