Cal. No. E650
Refine your searchE650
Receiving the time signal
Receiving the time signal manually (On demand reception)
!
For details of signal reception, see “About signal reception”.
!
It takes up to 15 minutes to finish signal reception.
!
In areas where summer time is implemented, it is convenient to execute procedures in “Setting summer time” before reception.
- Pull the crown out to position 1.
- Rotate the crown to change the mode to any one of the following: [LON], [NYC], [CHI],[DEN] or [LAX].
- Push the crown in to position 0.
- Press and hold the lower right button A for 2 seconds or more until the second hand points “RX”.
- Put the watch in the place with good conditions for time signal reception.
The second hand points to 30 seconds and stops.
!
Available signal station is different depending on the mode you use.
[NYC], [CHI], [DEN] and [LAX]: signals from the US station are received.
[LON]: signals from the Germany station are received.
Other modes: no signal reception is executable.
The second hand indicates the result of the last signal reception.
After that, the second hand points to “RX” and signal reception starts.
!
Do not move the watch as far as possible while the second hand points “RX”.
After the reception finished, the reception result (H/M/L/NO) of this time is indicated and the watch returns to normal indication.
To cancel signal reception
Pressing and holding the lower right button A while the second hand points “RX” cancels signal reception and the watch returns to normal indication.