Features

Troubleshooting


F990

Problems with satellite signal reception

Reception is unsuccessful.

Below are possible causes. Try remedies from the top to the bottom.

CauseRemedies
The mode is not [TME] or [UTC].Change the mode to [TME] or [UTC].
The second hand moves every two-second.Charge the watch.
The second hand does not point [RX-TME] or [RX-GPS]. Press and hold the button until the second hand points [RX-TME] or [RX-GPS] (about 2 seconds).
Just after pressing the button, the second hand indicates the current setting and points [RX-TME] or [RX-GPS] after that.
If not, check and correct the reference position.
Place is not good for reception.Avoiding places where the satellite signal may be obstructed and objects which emit noise, face the dial towards the sky and start reception.
The place is good but the watch is worn on your wrist.Remove the watch from your wrist and try again.

If the remedies above do not solve the problems, consult an authorized service center.

Related articles

Changing the mode Obtaining location information from satellite signals Executing time reception For receiving the satellite signal smoothly Checking and correcting the reference position