Cal. No. H80*
Refine your searchH80*
Receiving the time signal
Receiving the time signal manually (On demand reception)
!
You cannot use this function while using the chronograph.
!
For details of signal reception, see “About signal reception”.
!
It takes up to 15 minutes to finish signal reception.
!
Signals to receive are different depending on the time zone you set for the world time.
For details, see “Table of time zones and representative places”.
- Push the crown in to position 0.
- Press and hold the lower right button A for 2 seconds or more.
- Put the watch in the place with good conditions for time signal reception.
The chronograph 1/20 second hand indicates the result of the last signal reception.
After that, the chronograph 1/20 second hand points to “RX” and signal reception starts.
!
Do not move the watch as far as possible while the chronograph 1/20 second hand points “RX”.
After the reception finished, the reception result (OK/ NO) of this time is indicated and the watch returns to normal indication.
To cancel signal reception
Pressing and holding the lower right button A for 2 seconds or more while the second hand points “RX” cancels signal reception and the watch returns to normal indication.