Cannot receive time signals

The chronograph 1/20 second hand does not point “RX”.

Below may be possible causes. Try the following remedies in sequence.

The chronograph is being used.Stop chronograph measurement.
Power reserve is not enough.
(The second hand moves every two-second.)
Charge the watch.
The crown is not in position 0.Push the crown in to position 0.
The chronograph 1/20 second hand points other place than “RX” because its reference position is incorrect.Check and correct the reference position.

Related articles

Using the chronograph Receiving the time signal manually (On demand reception) When receiving the time signal Checking and correcting the reference position